Tektronix TVS600 & TVS600A Series Manuel D’Utilisation
CALCulate Subsystem
TVS600 & TVS600A Command Reference
2–75
CALCulate:WMParameter:HREFerence:RELative
CALCulate:WMParameter:HREFerence:RELative?
CALCulate:WMParameter:HREFerence:RELative?
Sets or queries the high reference (distal) level used for time and amplitude
measurements. The level can be expressed as a ratio or percent of the current
value for CALC:WMP:AMPLitude. This setting is used when you have set
CALC:WMP:RMEThod to RELative.
measurements. The level can be expressed as a ratio or percent of the current
value for CALC:WMP:AMPLitude. This setting is used when you have set
CALC:WMP:RMEThod to RELative.
CALCulate<n>:WMParameter:HREFerence:RELative <hrefā>
CALCulate<n>:WMParameter:HREFerence:RELative?
<n>
1
Query response
1
2
3
4
2
3
4
Not applicable
1
The calculate block number <n> selects one of four calculate blocks. If you omit <n>,
the default is calculate block 1.
the default is calculate block 1.
<href> (Set relative value of HREF)
Query response
<NRf >
0.0
0.0
N 1.0
1
MINimum
MAXimum
MAXimum
<NR2>
0.0
1.0
1.0
1
The units must be specified as PCT when setting HREFerence:RELative as a percent
of the value AMPL.
of the value AMPL.
0.9
Execution Error –222, “Data out of range”
Attempted to set the high reference to an illegal value.
Attempted to set the high reference to an illegal value.
None
Command:
CALC1:WMP:HREF:REL 95 PCT
Query:
CALC1:WMP:HREF:REL?
Response:
0.95
Syntax
Parameters
Reset Value
Errors and Events
Dependencies
Examples