Tektronix TVS600 & TVS600A Series Manuel D’Utilisation

SYSTem Subsystem

TVS600 & TVS600A Command Reference

Sets or queries whether software flow control (XON/XOFF) is enabled for the
front panel RS-232 port. Both transmit and receive values are set by this
command. Refer to the TVS600 & TVS600A Series Waveform Analyzers User
Manual for the factory setting.

When you set :SERial:PACE, the new value is stored in nonvolatile RAM and is
recalled at power up. However, the flow control mode is not saved with stored
settings (*LRN) and it is not reset to a default value by *RST.

You should not use software flow control when transferring binary data.

SYSTem:COMMunicate:SERial:PACE <flow_control>

SYSTem:COMMunicate:SERial:PACE?

NONE
XON

NONE
XON

Not applicable

Execution Error –141, “Invalid character data”
Attempted to set the software flow control to an illegal value.

None

Command:

SYST:COMM:SER:PACE XON

Query:

SYST:COMM:SER:PACE?

Response:

XON

SYSTem:COMMunicate:SERial:CONTrol:DCD
SYSTem:COMMunicate:SERial:CONTrol:RTS
SYSTem:COMMunicate:SERial:PRESet:RAW
SYSTem:COMMunicate:SERial:PRESet:TERMinal