Tektronix TVS600 & TVS600A Series Manuel D’Utilisation

TRIGger[:A] Subsystem

TVS600 & TVS600A Command Reference

Changing the trigger source from INTernal to EXTernal or from one INTernal
source to another INTernal source with a different VOLTage:RANGe setting may
change the TRIGger:LEVel setting to accommodate a new vertical range.

Command:

TRIG:SOUR INT1

Query:

TRIG:SOUR?

Response:

INT1

ARM:SOURce
TRIGger:B:SOURce

Sets or queries the type of triggering to use for the next acquisition. The
available types are as follows:

 EDGE specifies the default triggering. A trigger event occurs when a signal

passes through a specified voltage level on the specified rising or falling
slope. The standard SCPI trigger commands control this mode.

 LOGic–A trigger event occurs when the specified combination of input

signals occur. (TVS600A models only)

 PULse generates a trigger event when a specified pulse is detected. It is

controlled by commands in the TRIGger[:A]:PULSe subsystem.

 SHOLdtime–A trigger event occurs when the specified clock-to-data setup

and hold time is violated. (TVS600A models only)

 TRANsition–A trigger event occurs when the input signal fails to transition

between two thresholds in the specified time. (TVS600A models only)

TRIGger[:A]:TYPE <trigger_type>

TRIGger[:A]:TYPE?

EDGE
LOGic
PULSe
SHOLdtime
TRANsition

EDGE
LOG
PULS
SHOL
TRAN