Smeg PLTW620 Manuel D’Utilisation
User instructions
31
FAULT
DESCRIPTION
E8
Alternate washing system malfunction
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
Interrupt the program and switch off the
dishwasher. Switch the dishwasher back on,
program it again and start the washing cycle. If
the problem persists, contact the after-sales
service.
E9
Water intake system malfunction
Contact the after-sales service.
Contact the after-sales service.
Light off
Light on
Light flashing
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
signals a fault.
•
Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
immediately.
•
The E5, E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
resolved, it will bring bach the execution of the program.
•
The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•
Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.
TECHNICAL DATA
Width
597
÷ 599 mm
Depth measured flush with the
outer edge of the control panel
outer edge of the control panel
Free standing: 600 mm
Semi-integrated: 570 mm
Semi-integrated: 570 mm
Height
Free standing from 850 mm to 870 mm
Semi-integrated from 820 mm to 870 mm
Semi-integrated from 820 mm to 870 mm
Capacity
12 Standard place settings
Water supply pressure
min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics
See rating plate
Bio
Bio