Heartland 3530 Manuel D’Utilisation

Section 4: Oven and Clock Operation

1.

Press         bake symbol. (temperature is automatically set at 350F or 175C and the
        bake indicator light begins to flash)

2.

Press      increase or      decrease symbols to change temperature setting.  Temperature may be
set between 100F to 550F or 65C to 290C. (fast scrolling begins after holding       increase or

                  decrease symbol keys for over 5 seconds).

3.

Press         cook time symbol. (timer will display 00:00 and          cook time indicator will begin
to flash)

4.

Press      increase symbol until desired cook time is set. (fast scrolling begins after holding
     increase symbol key for over 5 seconds).

5.

To correct time set press      increase or      decrease as needed.

 (please read all steps prior to setting the regular bake function)

1.

 Press        bake symbol. (temperature is automatically set at 350F or 175C and the

          bake indicator light begins to flash)

2.

Press      increase or      decrease symbols to change temperature setting.  Temperature may
be set between 100F to 550F or 65C to 290C. (fast scrolling begins after holding
    increase or      decrease symbol keys for over 5 seconds).

3.

Press          start symbol to begin regular bake function.          bake indicator light will glow.
After 5 seconds the time of day and temperature in oven will be displayed.  Temperatures will
be displayed in increments of 5F or 5C until programmed temperature is reached.

4.

Once set temperature is reached, an audible signal will sound.

5.

Press        cancel symbol to end regular bake function at any time.          bake indicator light
and temperature display will go off.  Only time of day will be displayed.

Note:
1.

To verify oven temperature set during programming while the oven is heating up, press     .

bake symbol.  Information will be displayed for 5 seconds.

2.

The red indicator, located at the top right corner beside the oven temperature, will be on when
the element is powered and will go off when the element cycles off.

 (please read all steps prior to setting the timed bake function)