Sharp Electric Rang Manuel D’Utilisation

To reduce the risk of tipping of the range, the range must be secured

to the floor by properly installed Anti-Tip bracket and screws packed 

with the range. Failure to install the Anti-Tip bracket will allow the

range to tip over if excessive weight is placed on an open door or if

a child climbs upon it. Serious injury might result from spilled hot

liquids or from the range itself.
If range is ever moved to a different location, the Anti-Tip bracket

must also be moved and installed with the range. Instructions are

provided for installation in wood or cement fastened to either the floor 

or wall. When installed to the wall, make sure that screws completely

penetrate dry wall and are secured in wood or metal. When fastening

to the floor or wall, be sure that screws do not penetrate electrical 

wiring or plumbing.

A

The bracket may be located on either the left or right side of the

range. Refer to figure 13B to locate the bracket if template is not 

available.

Mark the floor or wall where left or right side of the range will be 

located. If rear of range is against the wall or no further than 1

1/4-inches from wall when installed, you may use the wall or floor 

mount method. See Figure 14. If molding is installed and does not

allow the bracket to fit flush against the wall, remove molding or 

mount bracket to the floor. For wall mount, locate the bracket by 

placing the back edge of the template against the rear wall and the

side edge of template on the mark made referencing the side of the

range. Place bracket on top of template and mark location of the

screw holes in wall. If rear of range is further than 1 1/4-inches from

the wall when installed, attach bracket to the floor. See Figure 15. For 

floor mount, locate the bracket by placing back edge of the template 

where the rear of the range will be located. Mark the location of the

screw holes, shown in template.

terminal

block

ground

screw

ground

screw

ground

wire lead

ground plate

ground

plate

ground strap

line 2

neutral

line 1

proper ground

for 4-wire

permanent

terminal

block

ground

screw

ground

screw

ground

wire lead

ground plate

ground

plate

ground strap

line 2

neutral

line 1

proper ground

for 4-wire

permanent

13 3/8" from the center of

the wall opening to the edge

of the backet.

13

3

/

8

"

13

3

/

8

"

The edge of the template

should be aligned with the left

or right edge of the range.

15"

15"