Hearth & Home Technologies 810-02901 (MBK) Manuel D’Utilisation
Page 10
250-7251F
September 1, 2008
R
Castile Pellet Insert
Mark area of
floor to cut
floor to cut
Starter hole
Use 2 x 4 from insert
packaging to support insert
packaging to support insert
Keep sharp edge of
metal floor away from
power cord
metal floor away from
power cord
F. Removing Metal Floor of Factory-Built Firebox
•
The firebrick (refractory), glass doors, screen rails, screen
mesh and log grates can be removed from a factory-built
firebox in order to gain minimum insert opening require-
ments.
firebox in order to gain minimum insert opening require-
ments.
• Any smoke shelves, shields and baffles may be removed
from a factory-built firebox if attached with mechanical fas-
teners.
teners.
•
The metal floor of the factory-built firebox may be removed
to facilitate the installation of the insert only when a 1/4
(6mm) inch airspace is provided between the insert and
the floor of outer wrap.
(6mm) inch airspace is provided between the insert and
the floor of outer wrap.
Figure 10.1. Measure and mark the metal
floor for cutting. With a drill, make a starter
hole in each corner.
floor for cutting. With a drill, make a starter
hole in each corner.
Figure 10.2. Using a saws-all, cut out the
floor
floor
Figure 10.3. If the floor is made of thin metal,
we recommend using the 2 x 4 from the insert
packaging to support the insert. The 2 x 4
may need to be cut to the appropriate size.
we recommend using the 2 x 4 from the insert
packaging to support the insert. The 2 x 4
may need to be cut to the appropriate size.
Figure 10.4. Place the insert into the fac-
tory-built firebox. Ensure that the power
cord can not be damaged by the sharp metal
edge. You may need to cut out a notch to
accommodate the cord.
tory-built firebox. Ensure that the power
cord can not be damaged by the sharp metal
edge. You may need to cut out a notch to
accommodate the cord.
The following is only one example as there are many dif-
ferent models of factory-built fireplaces.
ferent models of factory-built fireplaces.
NOTE: Ensure that the leveling leg is posi-
tioned over the 2 x 4 before leveling the
insert. See page 16, for detailed instructions
on how to adjust the leveling legs.
tioned over the 2 x 4 before leveling the
insert. See page 16, for detailed instructions
on how to adjust the leveling legs.