Panasonic PAN4570 Manuel D’Utilisation

CLASSIFICATION 
Einstufung 

 

No. 
DS-Eval4570-2400 

REV. 

C 

SUBJECT 
Thema 

EvalBoard PAN4570 

 

PAGE 
Seite 

 

4  of  20 

CUSTOMER’S CODE 
EvalPAN4570 

PANASONIC’S CODE 
 

DATE 
Datum 

 

06.11.2006 

 

 

European Technology Center 

Panasonic Electronic Devices (EUROPE) GmbH 

APPROVED 

genehmigt 

CHECKED 

geprüft 

DESIGNED 

Erstellt 

 

 To install and run the programs you need Administrator rights on the test PC. 

Check for software updates at  

. 

 
2. SETTING UP THE EVALBOARD 

 

Plug a PAN4570 Carrierboard on one of the three 34-pins headers (B or C or D) as 
shown in Figures 1 and 2. Please take care that pin 1 of the Carrierboard connects to 
pin1 of the testboard according to the “1” marking on the PCBs. 
 

Important:

 Only 1 PAN4570 carrierboard may be plugged on the testboard.  

 
The other 34-pin headers/sockets are provided for demo application boards like sensors, 
actuators, etc. On slot A a socket is mounted instead of double pin rows for applications 
using a plug with pins. For details on the testboard see chapter 3 and the testboard 
schematic in chapter 10. 
 
Mount the 50Ohms 2,4GHz antenna with SMA male plug on the PAN4570 carrierboard 
SMA socket. 
 
Check if a Vcc=+2,7Vdc module supply jumper is set to the corresponding 2-pin header  
(B or C or D).  
Remark: Instead of a jumper an amperemeter for measuring the module current on VCC 
can be connected to the module supply 2-pin header. In this case the voltage drop at the 
amperemeters internal resistor reduces the Vcc voltage applied to PAN4570 depending 
on the current drawn. Therefore check if the amperemeter used has an internal 
resistance of sufficiently low value. 
 
As an option a +5Vdc regulated voltage is available on the 34-pins headers (this does not 
apply to usage of USB as power supply). 
 

 Do not connect the +5Vdc directly to PAN4570 because it may damage the 

 

        

Module. 

 
The reason for the +5Vdc option are applications needing a higher supply voltage (i.e. 
with white LEDs). In order to use +5Vdc on the headers it has to be connected by 
plugging a jumper to position JP2.  
 
The total available current from Vcc plus the current from +5Vdc is approximately 270mA 
maximum, provided that the power source voltage applied to P1-P2-P3 does not drop 
below approximately 6,6Vdc. 
 
For the location of switches and jumpers on the Evaluation board see