DELL 34XX Manuel D’Utilisation
Parameter
Description
readOnly
This parameter sets the snapshot virtual disk to
read-only. This parameter is actually a Boolean;
however, in the context of this command, the
Boolean value is always TRUE.
read-only. This parameter is actually a Boolean;
however, in the context of this command, the
Boolean value is always TRUE.
NOTE: With the readOnly parameter,
snapshot virtual disks are not created.
snapshot virtual disks are not created.
Notes
You can use any combination of alphanumeric characters, underscore (_), hyphen (-), and pound (#) for
the names. Names can have a maximum of 30 characters.
the names. Names can have a maximum of 30 characters.
The identifier of a snapshot image has two parts separated by a colon (:):
• The name of the snapshot group.
• The identifier of the snapshot image.
• The identifier of the snapshot image.
For example, if you want to create a read-only virtual disk named engData1 using the most recent
snapshot image in a snapshot group that has the name snapGroup1, you would use this command:
create snapVirtualDisk userLabel="engData1" snapImageID="snapGroup1:newest"
snapshot image in a snapshot group that has the name snapGroup1, you would use this command:
create snapVirtualDisk userLabel="engData1" snapImageID="snapGroup1:newest"
readOnly;
Create Remote Replication
NOTE: This command is valid only with Fibre Channel storage arrays.
Description
This command creates both the primary virtual disk and the secondary virtual disk for a remote
replication pair. This command also sets the write mode (Synchronous or Asynchronous) and the
synchronization priority.
replication pair. This command also sets the write mode (Synchronous or Asynchronous) and the
synchronization priority.
Syntax
create remoteReplication primary=
”primaryVirtualDiskName”
secondary=”secondaryVirtualDiskName”
(remoteStorageArrayName=”storageArrayName” |
remoteStorageArrayWwn=”wwID”)
[remotePassword=”password”
syncPriority=(highest | high | medium | low |
lowest)
autoResync=(enabled | disabled)
writeOrder=(preserved | notPreserved)
writeMode=(synchronous | asynchronous)]
182