Furuno 1833C Manuel D’Utilisation

The FURUNO Display unit FMD-811, MODEL1832 or GD-280/380, etc. can be connected 
to the NavNet display as remote display. To interconnect them, use a cable attached with or 
set as option for the remote display. For the network system consists of some units, connect 
the remote display cable to the one selected as radar source. Also, the optional EMI core 
(Type: E04R241336A, Code No.:000-146-335) should be attached to the remote display 
cable to prevent a noise. 
 
1.  Unscrew 15 binding screws (M3x10, w/nylon washer) and seven connector nuts to 

remove the display unit cover. 

2.  Pass the signal cable for remote displaying through the hole at the rear of the display 

unit cover and the saddle on the POWER Board, and then connect the XH connector 
(8P) of the signal cable to J109 on the SPU Board. If your remote signal cable has the 
ground wire, pass it outside of the cover and fix it with the screw shown below. 

3.  Reassemble the display unit referring to the illustration on page 4-3. 
4.  Attach the EMI core (option) to the remote display cable at the closed position to the 

display unit. 

 

Connector nut
(small) 5 pcs.

Connector nut
(for 24P) 1 pc.

Connector nut
(large) 1 pc.

Binding screws
(M3x10, w/nilon washer)
15 pcs.

Other equipment's
remote signal cable

Saddle

J109

Use one of 
these screws 
to fix the ground 
wire of the remote 
signal cable.

Attach EMI core closely
to the display unit.