Multiquip jwn24hscsl Manuel D’Utilisation

Page de 44
page 18 — JWN-SeRIeS RIDe-ON pOWeR TROWeL • OpeRaTION maNuaL — Rev. #1 (05/12/12) 
BaSic enGine
1
2
3
5
12
13
14
6
4
7
8
9
10
11
ENGINE FUEL
 ONL
Y
Figure 4. Engine Components
INITIaL SeRvICINg
The  engine  (Figure  4)  must  be  checked  for  proper 
lubrication and filled with fuel prior to operation. Refer to the 
manufacturer's engine manual for instructions and details 
of operation and servicing. 
1. 
muffler — Used to reduce noise and emissions.
2. 
air Cleaner — Prevents dirt and other debris from 
entering the fuel system. Unsnap air filter cover to gain 
access to filter element.
3. 
Choke Knob — Used in the starting of a cold engine 
or in cold weather conditions. The choke enriches the 
fuel mixture.
4. 
engine  ON/OFF  Switch  —  "ON"  position  permits 
engine starting, "OFF" position stops engine operations.
5. 
Fuel Filter — Filters fuel for contaminants. 
6. 
Oil Filter — Spin-on type, filters oil for contaminants.
 WaRNINg
Engine components can generate extreme 
heat. To  prevent  burns, 
DO  NOT  touch 
these areas while the engine is running or 
immediately after operating. 
NeveR operate 
the engine with the muffler removed.
7. 
Throttle Lever  — Controlled by  accelerator  pedal, 
increases or decreases engine RPM.
8. 
Oil Filler Cap — Remove to add engine oil.
9. 
Oil  Dip  Stick  —  Remove  to  check  amount  and 
condition of oil in crankcase.
10. 
Starter — Starts engine when ignition key is rotated 
to the "ON" position.
11. 
Oil Drain plug — Remove to drain crankcase oil.
12. 
Spark plug — Provides spark to the ignition system. 
Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) 
Clean spark plug once a week.
13. 
Fuel Tank  —  Five  gallon  capacity;  use  unleaded 
gasoline.
14. 
Fuel Filler Cap — Remove this cap to add unleaded 
gasoline to the fuel tank. Make sure cap is tightened 
securely. 
DO NOT overfill.
 DaNgeR
Add fuel to the tank only when the engine 
is stopped and has had an opportunity to 
cool down. In the event of a fuel spill, 
DO 
NOT attempt to start the engine until the fuel 
residue has been completely wiped up and 
the area surrounding the engine is dry.