3com 5101T-FB-SMA Manuel D’Utilisation
Page 11
Half Step Mode
When enabled, half step is signaled at the
beginning of packets, as required in IEEE 802.3
and Ethernet Version 2.0. The default setting is
enabled.
beginning of packets, as required in IEEE 802.3
and Ethernet Version 2.0. The default setting is
enabled.
When disabled, the signaling on the AUI receive
pair (DI) is the same as defined in Ethernet
Version 1.0. This is a full step waveform at the
beginning of a packet.
pair (DI) is the same as defined in Ethernet
Version 1.0. This is a full step waveform at the
beginning of a packet.
Installation
This section describes the following consider-
ations for the 10BASE-FB Transceiver:
ations for the 10BASE-FB Transceiver:
■
Site Preparation and Placement
■
Unpacking Procedures