3com WXR100 3CRWXR10095A Manuel D’Utilisation
388
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
Usage — You can configure the transmit power of a radio on the same
command line. Use the tx-power option.
command line. Use the tx-power option.
This command is not valid if dynamic channel tuning (RF Auto-Tuning) is
enabled.
enabled.
Examples — The following command configures the channel on the
802.11a radio on the MAP access point connected to port 5:
802.11a radio on the MAP access point connected to port 5:
WX1200# set ap 5 radio 1 channel 36
success: change accepted.
The following command configures the channel and transmit power on
the 802.11b/g radio on the MAP access point connected to port 1:
the 802.11b/g radio on the MAP access point connected to port 1:
WX1200# set ap 1 radio 1 channel 1 tx-power 10
success: change accepted.
See Also
set ap radio
link-calibration
link-calibration
Configures an MAP radio to emit link calibration packets, which can aid
in positioning a Mesh AP.
in positioning a Mesh AP.
Syntax — set ap ap-number radio {1 | 2} link-calibration mode
{enable | disable}
{enable | disable}
ap ap-number
— Index value that indentifies the MAP on the WX.
radio 1
— Radio 1 of the MAP.
radio 2
— Radio 2 of the MAP. (This option does not apply to
single-radio models.)
mode enable
— Enables link calibration packets for the MAP radio.
mode disable
— Disables link calibration packets for the MAP radio.
Defaults
—
Disabled.
Access
—
Enabled.
History
—
Introduced in MSS Version 6.0.