Jabra GO 6470 Manuel D’Utilisation

22

Jabra GO 6470 User manUal

1.  If you have not already done so, then set the clear dial-tone switch as described above.

2.  follow the on-screen instructions. 

  If the base has contact with the Jabra test server, it determines the optimal microphone level automatically.

  If the base cannot contact the test server, you can re-try or you can try to set the mic.-level manually — see the 

procedure below.

If the Jabra GO base cannot contact the Jabra test server:
In this case, you can choose to set the mic.-level manually:

1.  If you have not already done so, then set the clear dial-tone switch as described above.

2.  make arrangements to call a friend who is not sitting nearby. tell your friend that you will be testing your 

headset and ask him or her not to adjust his or her own telephone volume during the test.

3.  Call your friend by doing the following:

-  wear the headset and position its microphone close to your mouth.

-  press the headset button on your desk phone (or lift the handset) to connect to the phone network.

-  dial your friend’s number using your desk-phone buttons.

4.  as you speak with your friend, adjust the mic.-level control on the Jabra GO touchscreen (desk phone setup 

wizard, manual setup) until your friend tells you that your voice sounds clear (loud enough) but not distorted 

(too loud). 

MANUAL SETUP

Set microphone level

  the desk phone part of the setup wizard guides you through. remind your friend not to adjust his or her own 

volume during the test.

  If your best mic.-level setting turns out to be the loudest possible and you found more than one best position 

for the clear dial-tone switch, then move the clear dial-tone switch to the alternative setting and try again to 

find the best mic.-level together with your friend. If this time the mic.-level is not set to the maximum, then 

keep this new combination of settings.

5.  press the headset button on your desk phone (or replace the handset) to hang up. then dock the headset (the 

audio link from the headset to your desk phone closes automatically when you dock the headset). 

  your headset is now ready for use.

4.6  uSing a handSet lifteR oR electRonic hookSwitch

with traditional desk phones, you must lift the handset (or press a desk phone headset button, if present) 

whenever you want to place or receive a call. however, you can automate this connection by adding one of the 

following:

-  Jabra GN1000 remote handset lifter, which will work with nearly any phone.

-  an electronic hookswitch connection, which requires a supported desk phone and a phone-specific adapter 

from Jabra.  

In the desk phone setup wizard, you can select between DHSG, MSH, Cisco or RHL adapter types.

electronic solutions such as these enable you to answer an incoming call when away from your desk simply by 

pressing a button on the headset. they also tell the base when your desk phone is ringing, thereby setting the 

desk phone as the current target phone automatically. the Gn1000 and most electronic hookswitch solutions 

support ring detection.