Jabra GO 6470 Manuel D’Utilisation

45

Jabra GO 6470 User manUal

power being turned off

red 100ms
Off 100ms
repeats to a total of 3 times

same as for good battery level

pairing

Constant blue

Constant red

pairing succeeded

Blue 200ms
Off 400ms
repeats to a total of 5 times

red 100ms
Off 300ms
repeats to a total of 5 times

Charging

Constant yellow

Constant red

fully charged in cradle

Constant green

n/a

7.6  BatteRy indicatoRS and RechaRge

Battery indicators
the headset (and Jabra GO base) indicate the current headset battery level as follows:

-  the headset led indicates, among other things, its battery and charging status; see the table above for details.

-  while the battery is low, you will hear an audio signal (two quick, low tones) every minute or so in the headset.

-  when the headset is paired with a Jabra GO base, you can read the current battery level on the touchscreen.
Recharging the Headset
to recharge your headset battery, do one of the following:

-  place the headset in its cradle on the Jabra GO base. see also Section 4.3: Assembling the Jabra Go Base and 

headset.

-  place the headset into its travel Charger and connect the charger to power. see also Section 9.3: Charging the 

headset with the travel Charger.

7.7  PoweR Save Mode

you can choose to put the headset into power save mode. the means that the headset saves power at the 

expense of a slightly reduced range. 
you can enable/disable power save mode from the base touchscreen (Advanced Settings menu) and Jabra 

Control Center. power save mode is disabled by default).
In some circumstances, you can use power save mode to improve sound quality if the sound becomes distorted. 

this can happen, for example, with an active call and a call on audio-hold. to do this; enable power save mode, 

then close and re-open the audio link. 
you can also enable power save mode if you want to use a larger number of headsets within a given area.
see the section “high Capacity Jabra Go Installations” for more on density and “Staying within Range” for more on 

range.
power save mode uses the Bluetooth® enhanced data rate (edr) feature.