3com WX4400 3CRWX440095A Manuel D’Utilisation

C

HAPTER

 20: F

ILE

 M

ANAGEMENT

 C

OMMANDS

Clears the filename specified as the backup configuration file. In the 
event that MSS cannot read the configuration file at boot time, a backup 
configuration file is not used.

Syntax — 

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 4.1.

Examples — The following command clears the name specified as the 
backup configuration file from the configuration of the WX switch:

WX4400# clear boot backup-configuration

success: Backup boot config filename was cleared.

„

„

Resets to the factory default the configuration that MSS loads during a 
reboot. 

Syntax — 

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following commands back up the configuration file on 
a WX switch, reset the switch to its factory default configuration, and 
reboot the switch:

WX4400# copy configuration tftp://10.1.1.1/backupcfg

success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]

WX4400# clear boot config

success: Reset boot config to factory defaults.