Alliance Laundry Systems CHM1772C Manuel D’Utilisation
Maintenance
F8208401
14
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill the machine.
b. Verify that door and door gasket do not leak.
c. Verify that the drain valve is operating and
that the drain system is free from obstruction.
If water does not leak out during the first
wash segment, the drain valve is closed and
functioning properly.
For F and variable-speed models only, clean the AC
drive box filter(s) weekly or more frequently as
needed:
1. Wash the filter with warm water and allow filter
to air dry. As an alternative, the filter may be
vacuumed clean.
IMPORTANT: The control module cover and fan
filter must be in place for the fan to properly cool
the AC inverter drive. Failure to observe this
warning will void the warranty and could lead to
expensive AC inverter drive repair.
Monthly
NOTE: Disconnect power to the machine at its
source before performing the monthly maintenance
procedures.
1. Use the following procedures to determine if
V-belt(s) require replacement or adjustment. Call
a qualified service technician in either case.
a. Check V-belt(s) for uneven wear and frayed
edges.
b. For groove-pulley drive systems, verify
alignment by placing a straightedge across
both pulley faces. The straightedge should
make contact with the pulleys in four places.
Refer to Figure 7.
Figure 7
H040I
1
Motor
2
Motor Pulley
3
Straightedge
4
Basket Pulley
H040I
1
2
3
4