Q-Logic 8100 Manuel D’Utilisation

6–iSCSI Noninteractive Commands
Command Summary

6-2

SN0054667-00  C

The positional parameters vary, depending on the command option specified. For 
example, to display an adapter’s configured settings, use the command option -C, 

followed by the port instance number (positional parameter). In contrast, the 
command for providing general information, -g, has no positional parameters.
In noninteractive mode, most changes made to the port instance become effective 
immediately. This sometimes causes the adapter to reset, as specified in the 
command description. Be sure the system is prepared for an adapter reset before 
making changes.

This remainder of this chapter contains an alphabetical list of QConvergeConsole 
CLI commands used in noninteractive mode.

This section lists and describes each command line option in alphabetic order, 
followed by a command description.

To inquire whether the access method control block (ACB) firmware functions are 
supported, issue the -acb command. In general, up-to-date firmware and driver 

are required for ACB to be supported.

CHAP Name Null-terminated CHAP name, which is sent by the port 

instance when responding to the CHAP challenge

CHAP Secret CHAP secret, which is used by the port instance when gener-

ating the CHAP response

Boot Target The target ID of the target device from which to boot

Boot LUN The LUN of the boot device



The commands are case sensitive. For example, -g is not the same as 
-G.



Only one command line option per input file is valid.

 <hba_port_inst> is an instance number from the list of all iSCSI 

adapter ports in the system. You can see this list with the command -i.