Q-Logic 8100 Manuel D’Utilisation

10–Converged Network Adapter Interactive Commands

CNA FCoE Configuration

SN0054667-00  C

10-27

From the HBA Parameters menu, select the Configure HBA Parameters option 
to open the Configure Parameters Menu. Select the parameter option and change 
the value. Refer to 

 for details about these parameters and their values. 

For example:

    1:  Connection Options
    2:  Data Rate
    3:  Frame Size
    4:  Hard Loop ID
    5:  Loop Reset Delay (seconds)
    6:  Enable BIOS
    7:  Enable HBA Hard Loop ID
    8:  Enable Fibre Channel Tape Support
    9:  Operation Mode
   10:  Interrupt Delay Timer (100ms)
   11:  Execution Throttle
   12:  Login Retry Count
   13:  Port Down Retry Count
   14:  Enable LIP Full Login
   15:  Link Down Timeout (seconds)
   16:  Enable Target Reset
   17:  LUNs per Target
   18:  Enable Receive Out Of Order Frame
   19:  Commit Changes
   20:  Abort Changes

From the HBA Parameters menu, select the Restore Defaults to restore adapter 
parameters to their factory default values.



Restoring the adapter parameters can make the adapter inoperable.



When restoring NVRAM parameters, the current BIOS device settings 
are also cleared.