Q-Logic 8100 Manuel D’Utilisation

5–Fibre Channel Noninteractive Commands

-m (View, Enable, or Disable LUNs)

SN0054667-00  C

5-25

To view the current select state of a specific LUN, issue the following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) (<target wwnn> 
<target wwpn> <lun id>) (view | info)

If the input represents a valid LUN, QConvergeConsole CLI shows that LUN’s 
current state as selected or deselected for that adapter.

To enable (select) a LUN on a specific target on a specific adapter, issue the 
following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) {<target wwnn> 
<target wwpn> <lun id> ( 1 | enable | select )}

To disable (deselect) a LUN on a specific target on a specific adapter, issue the 
following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) {<target wwnn> 
<target wwpn> <lun id> (0 | disable | deselect)}

To enable (select) all LUNs for a specific target on a specific adapter, issue the 
following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) select | enable 
<target wwnn> <target wwpn>

To disable (deselect) all LUNs for a specific target on a specific adapter, issue the 
following command:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect | disable 
<target wwnn> <target wwpn>

To enable (select) all LUNs of all targets on a specific adapter:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) select all

To disable (deselect) all LUNs of all targets on a specific adapter:

# qaucli -pr fc -m (<hba instance> | <hba wwpn>) deselect all

You can repeat the sequence <target wwnn> <target wwpn> <lun 
id> 1 to select multiple LUNs in the same command.

To select multiple LUNs in the same command, repeat the following 
sequence:

<target wwnn> <target wwpn> <lun id> 0