Leica 1000Z01 Manuel D’Utilisation

© Leica

TPS-System 1000 Programs-2.3.1en

Traverse

Introduction

This manual describes the "Traverse" program of the
TPS-System 1000 instruments.

PROG_Z17

E

H

N

Pt500

SP1

Hz2

Hz3

Hz1

Pt1

Pt2

Pt3

Pt501

Using data about direction and distance, the program
continuously computes the coordinates of the station (in
the example shown above, the instrument "moves" from
one station to the next, previously measured point) and
aligns the horizontal circle.
For a point the coordinates of which are known, the
deviation from the coordinates determined by
measurement can be computed and displayed.
There is no adjustment of these differences in
coordinates and direction. Subsequently, however, the
measurements stored on the PCMCIA can be processed
with the assistance of an appropriate software program.
Individual stations can be calculated as "sideshots"
(SP). The coordinates and directions of these points are
also determined in the course of this program.
If the program is terminated (e.g. to record a detail
point), the values remain stored. The measurement
procedure can be resumed after calling up the program
again.