Leica 1000Z01 Manuel D’Utilisation

TPS-System 1000 Programs-2.3.1en

© Leica

It is possible to insert also a new data set:

• With function "Coordinate", point coordinates,

station coordinates or a code block can be inserted.

• With function "Horizontal Alignment" a tangent, a

circular curve, a Spiral in, a Spiral out, a Curve in or
a Curve out can be inserted.
For the circular curve radius the following sign rule
applies:
With a right-hand curve (centre of circle right of
alignment) the sign is positive.
With a left-hand curve (centre of circle left of
alignment) the sign is negative.

• With function "Vertical Alignment" a tangent, a

circular curve or a parabola can be inserted.
For the circular curve radius and/or the parabola
parameter the following sign rule applies:

If the centre of circle is above the alignment (dip) the
sign is positive.
If the centre of circle is below the alignment (crest)
the sign is negative.

• With function "Template" an offset or a height

difference relative to axis can be inserted.
For the offset and/or the height difference the
following sign rule applies:
If the point is left of alignment the offset is negative.
If the point is right of alignment the offset is positive.
If the point is above the alignment the height
difference is positive.
If the point is below the alignment the height
difference is negative.

• With function "Station Equation" a number for the

station equation, a station ahead or a station back can
be inserted.

• With function "Cross-section Assignment" the name

of the template and the start station for  this template
can be inserted.