Leica 1000Z01 Manuel D’Utilisation
© Leica
TPS-System 1000 Programs-2.3.1en
39
IV
EL
AH
OH
RE
Resection
Introduction
This manual describes the "Resection" program of the
TPS SYSTEM 1000 theodolite series.
TPS SYSTEM 1000 theodolite series.
The program can be used to deduce the three-dimensio-
nal coordinates for the instrument station and the
orientation of the horizontal circle from measurements
to 2 target points with know Easting and Northing. To
compute the position coordinates, at least the distances
and the directions for both points are necessary.
nal coordinates for the instrument station and the
orientation of the horizontal circle from measurements
to 2 target points with know Easting and Northing. To
compute the position coordinates, at least the distances
and the directions for both points are necessary.
For simultaneous determination of the station elevation,
height of instrument and height of reflector must
already have been input and the elevation of the target
points must be known.
height of instrument and height of reflector must
already have been input and the elevation of the target
points must be known.
The program allows measurement in single or dual-face
mode.
mode.
H
N
PROG_Z02
E
H
0
0°00'00"
N
0
E
0
H
z1
Pt1
Pt2
H
z2
D
2
D
1