Mitsubishi Electronics C64 Manuel D’Utilisation

 

4 

<WRK COUNT> (No. of workpieces machined) 

8001  WRK COUNT M 

Set the M code that counts the No. of workpiece 
repeated machining. 
The No. will not be counted when set to 0. 

0 to 99 

8002  WRK COUNT 

The current machining No. is displayed. Set the 
initial value. 

0 to 999999 

8003  WRK LIMIT 

Set the maximum No. of workpieces machined. 
A signal is output to PLC when the No. of machining 
times is counted to this limit. 

0 to 999999 

 
<AUTO TLM> (Automatic tool length measurement)  

8004  SPEED 

Set the feedrate during automatic tool length 
measurement. 

1 to 1000000 
(mm/min) 

8005  ZONE r 

Set the distance between the measurement position 
and deceleration start point. 

0 to 99999.999 (mm) 

8006  ZONE d 

Set the tolerable zone of the measurement position. 
If the sensor signal turns on in front of d before the 
measurement position‚ or if the signal does not turn 
on after d is passed‚ an alarm will occur. 

0 to 99999.999 (mm) 

 
<AUTO CORNER OVR> (Automatic corner override)  

8007  OVERRIDE 

Set the override value for automatic corner override.  0 to 100 (%) 

8008  MAX ANGLE 

Set the max. corner opening angle where deceler- 
ation should start automatically.  
If the angle is larger than this value‚ deceleration will 
not start. 

0 to 180 (degrees) 

8009  DSC. ZONE 

Set the position where deceleration starts at the 
corner. 
Designate at which length point before the corner 
deceleration should start. 

0 to 99999.999 (mm) 

 
<T-TIP OFFSET> (Wear data input)  

8010  ABS. MAX.  

(For L system only) 

Set the max. value when inputting the tool wear 
compensation amount. 
A value exceeding this setting value cannot be set. 

0 to 99.999 (mm) 

8011 INC. MAX. 

(For L system only) 

Set the max. value for when inputting the tool wear 
offset amount in the addition mode. 

0 to 99.999 (mm)