GTO GP-SW050 Manuel D’Utilisation

Before you can gain access to the operator frame and its mounting holes, the housing will have to be

removed from the operator.

 

1.    Remove the (2) 3/8” allen bolts and (2) m8 washers from the operator housing (this hardware is

   located on each side of the housing).

2.     Lift the housing off the operator and set it aside.

with 5mm key

1.    Lift the operator and align its mounting holes over the 3/8” diameter concrete mounting anchors.

2.    Lower the operator into position and fasten it to the mounting anchors with (4) 3/8” washers and

 

   nuts (not provided).