Philips 9VD200 Manuel D’Utilisation

Only replace the adapter of the parent unit with an adapter of the original type. You can order a 

new adapter from your dealer or a Philips service centre: 

SBC CS0920/00W (EU/SGP only)

SBC CS0920/05W (UK only)

9VD200 (AU/NZ only)

Do not throw away the appliance with the normal household waste at the end of its life, but 

hand it in at an official collection point for recycling. By doing this, you help to preserve the 

environment (Fig. 11).

Batteries contain substances that may pollute the environment. Do not throw empty 

batteries away with the normal household waste, but hand them in at an official collection 

point. Always remove the batteries before discarding the appliance or handing it in at an 

official collection point.  (Fig. 12)

If you need service or information or if you have a problem, please visit the Philips AVENT website 

at www.philips.com/avent or contact the Philips Consumer Care Centre in your country (you 

can find the phone number in the worldwide guarantee leaflet). If there is no Consumer Care 

Centre in your country, go to your local Philips dealer. 

This chapter lists the questions most frequently asked about the appliance. If you cannot find the 

answer to your question, contact the Customer Care Centre in your country.

Question

Answer

Why is the power-on 

light not on?

Perhaps the appliance plug has not been inserted properly into the 

socket on the unit, or perhaps the adapter has not or not properly been 

inserted into the wall socket.
You may also have forgotten to switch on the units. Press the on/off 

button on the baby unit and turn the volume control on the parent unit 

downwards to switch on the units.
If you operate the units on batteries, the batteries may be low. In that 

case, replace the batteries.

Why does the power 

on light flash red?

You are operating the unit on batteries and the batteries are low. 

Replace the batteries.

Why does the parent 

unit produce a high 

pitched noise?

The units are too close together. Move the parent unit at least 1 metre/3 

feet away from the baby unit. If this does not help, the volume is too 

high. Turn the volume control to a lower volume.

Why is there no 

sound coming from 

the parent unit?

Check if the volume is set high enough. If the volume is too low, turn the 

volume control to a higher volume. Also check the microphone 

sensitivity of the baby unit.

-

-

-

,

,

11