VTech VM310-13 Fascicule

on purchasing your new VTech product. 
Before using this product, please read 
Important safety instructions.
This manual has instructions on how to set 
up and pair your new baby unit. For complete 
instructions on using the baby unit, see the 
user’s manual that came with your video and 
audio monitor.

For support, shopping, and everything new at 
VTech, visit our website at  
www.vtechphones.com.

Register your product online for 
enhanced warranty support.

Learn about the latest VTech 
products.

When using your equipment, basic safety 

precautions should always be followed to reduce the 

risk of fire, electric shock and injury, including the 

following:

Follow all warnings and instructions marked on 

the product.
Adult setup is required.
This product is intended as an aid. It is not 

a substitute for responsible and proper adult 

supervision and should not be used as such.
This product is not intended for use as a medical 

monitor.

1.

2.
3.

4.

Do not use this product near water. For example, do 

not use it next to a bath tub, wash bowl, kitchen sink, 

laundry tub or swimming pool, or in a wet basement 

or shower.

Use only the adapter included with this product. 

Incorrect adapter polarity or voltage can seriously 

damage the product.  

Baby unit power adapter: I

nput 100-240V AC 

150mA 50/60Hz; Output: 6V DC 600mA.

The power adapter are intended to be correctly 

oriented in a vertical or floor mount position. The 

prongs are not designed to hold the plug in place 

if it is plugged into a ceiling, under-the-table or 

cabinet outlet.
Unplug this product from the wall outlet before 

cleaning. Do not use liquid or aerosol cleaners. 

Use a damp cloth for cleaning.
Do not cut off the power adapter to replace it with 

other plug, as this causes a hazardous situation.
Do not allow anything to rest on the power cords. 

Do not install this product where the cords may be 

walked on or crimped.
This product should be operated only from the 

type of power source indicated on the

 

marking 

label. If you are not sure of the type of power 

supply in your home, consult your dealer or local 

power company.
Do not overload wall outlets or use an extension 

cord.
Do not place this product on an unstable table, 

shelf, stand or other unstable surfaces.
This product should not be placed in any area 

where proper ventilation is not provided. Slots and 

openings in the back or bottom of this product 

are provided for ventilation. To protect them from 

overheating, these openings must not be blocked 

by placing the product on a soft surface such as 

a bed, sofa or rug. This product should never be 

placed near or over a radiator or heat register.
Never push objects of any kind into this product 

through the slots because they may touch 

dangerous voltage points or create a short circuit. 

Never spill liquid of any kind on the product.

To reduce the risk of electric shock, do not 

disassemble this product, but take it to an 

authorized service facility. Opening or removing 

parts of the product other than specified access 

doors may expose you to dangerous voltages 

or other risks. Incorrect reassembling can cause 

electric shock when the product is subsequently 

used.
You should test the sound reception every 

time you turn on the units or move one of the 

components.
Periodically examine all components for damage.
Be aware of possible loss of privacy while using 

public airwaves. Conversations may be picked 

up by other nursery monitors, cordless phones, 

scanners, etc.

5.

6.

7.

8.

9.

10.

11.

12.

13.

14.

15.

16.

17.

18.
19.

Use only the baby unit power adapter 
supplied with this product. 
The baby unit power adapter is intended 
to be correctly oriented in a vertical or 
floor mount position. The prong are not 
designed to hold the plug in place if it is 
plugged into a ceiling, under-the-table or 
cabinet outlet.
Make sure the baby unit and the power 
adapter cord are out of reach of children.

•

•

•

1

2

Infrared LEDs
Backup light for night vision.

3

On when the baby unit is powered on 

and currently linked to parent unit.
Flashes when the baby unit is not 

linked to a parent unit; or  

the pairing process is in progress; or  

the parent unit is not viewing this baby 

unit.

•

•

4

5

Press to increase the listening volume.

Press to decrease the listening volume.
PAIR
Press and hold to pair to the parent unit.

Press and hold to turn on or off.

6

7

Tilt to adjust the camera angle.

8

9

r

Baby unit

Power outlet not 
controlled by a wall switch

Baby unit power adapter

Self-adhesive 
strap

To keep this product working well and looking good, 

follow these guidelines:

Avoid putting it near heating appliances and 

devices that generate electrical noise (for example, 

motors or fluorescent lamps).
DO NOT expose it to direct sunlight or moisture.
Avoid dropping the product or treating it roughly.
Clean with a soft cloth.
DO NOT immerse the baby unit in water and do 

not clean them under the tap.
DO NOT use cleaning spray or liquid cleaners.
Make sure the baby unit is dry before you 

connect them to the mains again.

•

•
•
•
•

•
•

Each newly purchased baby units (

VM310-13) must be paired to your video and 

audio monitor system (

VM311/VM311-13/

VM311-2/VM311-23).

You can pair a maximum of four baby 
units to your parent unit. 

Each new baby 

unit must be paired to the parent unit 
before use.
Make sure you power on the parent unit 
before pairing.

Press 

 when the parent unit is 

not in use

.

Press   or   to choose 

.

Press

   or   

to choose a desired baby unit 

slot, then press 

/SELECT. The screen 

displays  .

If you choose an occupied baby unit slot, 
the new baby unit will replace the existing 
baby unit.

4.  Press and hold   on the new baby unit 

until the 

POWER light flashes.  

Then immediately press and hold 

PAIR 

until the 

POWER light turns on.

When pairing is successful, the screen displays 

, and then the image from the newly paired 

baby unit.

If pairing fails, the screen displays  . Try 
the pairing process again.
Only one baby unit can be paired at a time.

Make sure you power on the baby unit and 
the parent unit before unpairing the baby unit.

Press 

 when the parent unit 

is not in use

.

Press   or   to scroll to  . 
Press   or   to select the desired baby unit 

(1, 2, 3 or 4).
Press and hold 

TALK until   and   

display.
Press   or   to select   to cancel, or   to 

confirm the unpair process.
Press 

/SELECT to confirm your selection.

When unpairing is successful, the 

POWER 

light on the selected baby unit flashes. The 

parent unit displays   for a while, and then the 

image from the baby unit previously viewing.

•

•

1.

2.
3.

•

•

1.

2.
3.

4.

5.

6.

Place the parent unit within the operating range 
of the baby unit. We recommend the parent 
unit is at least 3 feet away from the baby unit 
to avoid audio feedback. If you still experience 
audio feedback, move the parent unit and the 
baby unit farther apart.

For better image quality, do not place the 

baby unit too far away from your baby.

For desktop usage and/or wall mounting the 

baby unit, you can refer to 

Installation guide.

The operating range of the baby monitor is up 
to 1,000 feet outdoors or 150 feet indoors. The 
actual operating range may vary depending 
on the environmental conditions and other 
interferences such as walls, doors and other 
obstructions. 

Children should be supervised to ensure that they 

do not play with the product.
The product is not intended for use by persons 

(including children) with reduced physical, 

sensory or mental capabilities, or lack of 

experience and knowledge, unless they have 

been given supervision or instruction concerning 

use of the appliance by a person responsible for 

their safety.

Use and store the product at a temperature 

betw

een 32

o

F and 104

o

F.

Do not expose the product to extreme cold, heat 

or direct sunlight. Do not put the product close to 

a heating source.
Make sure the baby unit(s) and the adapter 

cord(s) are always out of reach of the baby, at 

least 3 feet away from the baby or crib, to avoid a 

possible strangulation hazard.
Never place the baby unit(s) inside the baby’s 

crib or p

laypen. Never cover the baby unit(s) with 

anything such as a towel or a blanket.
Other electronic products may cause interference 

with your baby monitor. Try installing your baby 

monitor as far away from these electronic devices 

as possible: wireless routers, radios, cellular 

telephones, intercoms, room monitors, televisions, 

personal computers, kitchen appliances and 

cordless telephones.

pacemakers
Cardiac pacemakers (applies only to digital cordless 

devices):
Wireless Technology Research, LLC (WTR), an 

independent research entity, led a multidisciplinary 

evaluation of the interference between portable 

wireless devices and implanted cardiac pacemakers. 

Supported by the U.S. Food and Drug Administration, 

WTR recommends to physicians that:

Should keep wireless devices at least six inches 

from the pacemaker.
Should NOT place wireless devices directly over 

the pacemaker, such as in a breast pocket, when 

it is turned ON.

WTR’s evaluation did not identify any risk to 

bystanders with pacemakers from other persons 

using wireless devices.

Electromagnetic fields (EMF)
This VTech product complies with all standards 

regarding electromagnetic fields (EMF). If handled 

properly and according to the instru

ctions in this 

user’s manual, the product is safe to be used based 

on scientific evidence available today.

20.

21.

1.

2.

3.

4.

5.

•

•