Remington Power Tools M35016AW Manuel D’Utilisation

Page de 76
21
www.remingtonpowertools.com
ENGLISH
 
TROUBLESHOOTING
 WARNING: Unplug chain saw from power source before servicing.  Severe injury 
or death could occur from electrical shock or body contact with moving chain.
Note: For additional help, visit DESA Power Tools technical service web site at
www.remingtonpowertools.com.
TECHNICAL SERVICE
You may have further questions about assembling, 
operating, or maintaining this product. If so, 
you can visit our Technical Service web site at 
www.remingtonpowertools.com or contact our 
Technical Service Department at 1-800-626-2237 
(English Only). You may also write to:
DESA Power Tools
ATTN: Technical Service
P.O. Box 90004
Bowling Green, KY  42102-9004
OBSERVED FAULT
POSSIBLE CAUSE
REMEDY
Saw runs, but does not 
cut
Chain assembled backwards on 
guide bar
See Assembly
Saw does not cut unless 
heavily forced. Cutting 
produces only sawdust 
with few large chips
Chain is dull
See Sharpening Saw Chain
Saw runs slow. Saw stalls 
easily
Low power supply voltage
Extension cord wire size too small. 
See Extension Cords.
Motor of saw does not 
run when you squeeze 
trigger
1.  Switch lockout not pushed for-
ward in to release trigger
2.  Extension cord connections 
loose
3.  Open line fuse or circuit breaker
4.  Worn out motor brushes
5.  Open wiring circuit on saw
1.  Push switch lockout forward 
before squeezing trigger
2.  Check cord connections
3.  Check line fuse or circuit breaker
4.  See authorized service center
5.  See authorized service center
Motor of saw runs, but 
chain does not move
Gear Sprocket
Remove and inspect gear sprocket 
for damage
Chain does not get oil
1.  Clogged oil slot in guide bar
2.  Oil is too thick
1.  Remove guide bar and clean oil 
slot
2.  Use correct weight of oil. See 
Filling Oil Tank
Chain comes off guide 
bar
1.  Chain is loose
2.  Guide bar and chain not as-
sembled correctly
1.  Tighten chain. See Saw Chain 
Tension Adjustment
2. See 
Assembly
Saw smokes
Saw damaged. Do not use saw
See authorized service center
Saw leaks oil
It is normal for oil to seep when the 
saw is not in use.
Tighten oil cap.
Note: Empty oil tank when not 
in use.
When contacting DESA Power Tools, have 
ready
• Your Name
• Your Address
•  Your Phone Number
•  Model Number of Product
•  Date of Purchase (Include copy of receipt for 
written requests).
We reserve the right to amend these specifi cations 
at any time without notice.  The only warranty 
applicable is our standard written warranty.  We 
make no other warranty expressed or implied.