Cub Cadet 928 SWE Manuel D’Utilisation

Pressing the primer bulb forces fuel directly into the engine’s 

carburetor to aid in starting a “Cold” engine. 

NOTE: Do not use the primer bulb to restart a warm engine after 

a short shutdown.

Engine oil level can be checked and oil added through the oil fill.

Position the skid shoes based on surface conditions. Adjust 

upward for hard-packed snow. Adjust downward when 

operating on gravel or crushed rock surfaces.

Requires the use of a three-prong outdoor extension cord and a 

120V power source/wall outlet.

This handle is used to manually start the engine.

Pressing the button on the top of the electric starter switch 

engages the engine’s electric starter when plugged into a 120V 

power source.

When engaged, the augers rotate and draw snow into the auger 

housing.

Snow drawn into the auger housing is discharged out the chute 

assembly.

Remove the gas cap to add gasoline to the fuel tank. 

The auger control is located on the left handle. Squeeze the 

control grip against the handle to engage the augers and start 

snow throwing action. Release to stop.

The drive control is located on the right handle. Squeeze the 

control grip against the handle to engage the wheel drive. 

Release the handle to stop. 

The drive control also locks the auger control so that you can 

operate the chute directional control without interrupting 

the snow throwing process. If the auger control is engaged 

simultaneously with the drive control, the operator can release 

the auger control (on the left handle) and the augers will remain 

engaged. Release both controls to stop the augers and wheel 

drive. 
NOTE: Always release the drive control before changing speeds. 

Failure to do so will result in increased wear on your machine’s 

drive system.