Hubbell Electric Heater Company EMV Manuel D’Utilisation
2
HUBBELL
ELECTRIC HEATER COMPANY
P.O. BOX 288
STRATFORD, CT 06615
PHONE: (203) 378-2659
FAX: (203) 378-3593
FAX: (203) 378-3593
INTERNET:
-- IMPORTANT --
Always reference the full model number and serial number when calling the factory.
WARNING / CAUTION
1. Tank is to be completely filled with water and all air is to be vented before energizing.
2. Due to the rigors of transportation, all connections should be checked for tightness before heater is
placed in operation.
3. Safety relief valve must be installed in tapping provided.
4. The refractory material used in heating elements may absorb some moisture during transit, periods of
storage, or when subjected to a humid environment. This moisture absorption results in a cold insulation
resistance of less than twenty (20) megohms. If this heater has been subjected to the above condition,
each heating element must be checked for insulation resistance before energizing. A low megohm
condition can be corrected by removing the terminal hardware and baking the element in an oven at
350°F -700°F for several hours or until the proper megohm reading is obtained.
resistance of less than twenty (20) megohms. If this heater has been subjected to the above condition,
each heating element must be checked for insulation resistance before energizing. A low megohm
condition can be corrected by removing the terminal hardware and baking the element in an oven at
350°F -700°F for several hours or until the proper megohm reading is obtained.
5. KEEP AWAY FROM LIVE ELECTRICAL CIRCUITS.
Do not perform any maintenance, make any adjustments, or replace any components inside the control
panel with the high voltage power supply turned on. Under certain circumstances, dangerous potentials
may exist even when the power supply is off. To avoid casualties, always turn the power supply safety
switch to off, turn the charge or ground the circuit before performing any maintenance or adjustment
procedure.
panel with the high voltage power supply turned on. Under certain circumstances, dangerous potentials
may exist even when the power supply is off. To avoid casualties, always turn the power supply safety
switch to off, turn the charge or ground the circuit before performing any maintenance or adjustment
procedure.
6. The unit is designed to operate at pressure not more than 150 psi.
7.
Generalized instructions and procedures cannot anticipate all situations. For this reason, only qualified
installers should perform the installations. A qualified installer is a person who has licensed training and
a working knowledge of the applicable codes regulation, tools, equipment, and methods necessary for
safe installation of an electric resistance water heater. If questions regarding installation arise, check
your local plumbing and electrical inspectors for proper procedures and codes. If you cannot obtain the
required information, contact the company.
installers should perform the installations. A qualified installer is a person who has licensed training and
a working knowledge of the applicable codes regulation, tools, equipment, and methods necessary for
safe installation of an electric resistance water heater. If questions regarding installation arise, check
your local plumbing and electrical inspectors for proper procedures and codes. If you cannot obtain the
required information, contact the company.