Lightolier A0200 Manuel D’Utilisation

6.   Select the appropriate wiring diagram to connect the emergency pack and the AC ballast: (See Pages 2 & 3)

An unswitched source of power is required for the emergency pack.

personnel.

eyes. If acid is spilled on skin or eyes, flush with fresh water and contact a physician immediately.

emergency pack are turned off at the fuse box. Servicing should be  performed by qualified personnel only.

end of the emergency pack). Make certain that the switch (if the fixture is switched) and the unswitched lines to the

10. Before servicing to prevent electrical shock, disconnect the battery connectors on the emergency pack (located on the

normal and the emergency power supplies before servicing.

9. This unit has more than one power supply connection piont. To reduce the risk of electrical shock, disconnect both the

8.  Do not use the equipment for other than intended use.

7.  The use of accessory equipment is not reccommended by the manufacturer and may cause an unsafe condition.

6.  Equipment should be mounted in locations and at a height where it will not be readily subject to tampering by unauthorized

may burst or release toxic materials. Do not short circuit; may cause burns. Battery acid can cause burns to skin and

5.  Do not attemp to service the battery. A sealed, rechargeable, no maintance battery is used. Do not incinerate or mutilate;

4.  Do not mount near gas or electrical heaters.

3.  Do not use outdoors.

are connected.

2.  Be sure all electrical connections are complete and outlet box is closed before battery connectors on emergency pack

1.   Turn off AC power before proceeding.

3.  The emergency pack must be fed from the same branch circuit as the AC ballast(s).

1.   Make sure AC power is off at fuse box.

2.  Make sure that the necessary branch circuit wiring is available.

4.  In switched fixtures, emergency pack must be connected ahead of any local switching.

connectors on emergency pack are connected.

5.  Be sure all electrical connections are made and outlet box is closed before battery

631 Airport Road, Fall River, MA 02720

before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

To assure full compliance with local codes and regulations, check with your local electrical inspector

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.