Lightolier F7000-28 Fascicule

Job Information 

Type:

Job Name: 

Cat. No.: 

Lamp(s): 

Notes:

 

"JSQPSU3PBE 'BMM3JWFS ."t t'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt

Lighting Systems

1BHFPG

'4FSJFT-JHIU5-FOT8BMM.PVOU

E0808

1. Housing: Single piece of high purity extruded aluminum, a portion from

recycled material.

2. Housing End: Die-cast aluminum, welded in place.
3. End Cap: Die-cast aluminum. Encloses the end of the run.
4. Lamps: F28T5 or F54T5HO as specified. By others. Installed from the ceiling

side of the luminaire.

5. Ballast: Electronic. Meets ANSI starting, end-of-life protection and sound

rating specifications. Low THD.

6. Lens: Two-piece compound lens consisting of injection-molded, bidirectional

prismatic acrylic with an extruded, linear prismatic acrylic lower layer.

Connections: Pre-wired with 18 gauge wires and polarized cannon plug 
connectors for simultaneous mechanical/electrical connection.
Emergency Battery Pack: 90 minute operation, 700 lumens for 54W and 520
lumens for 28W.
Dimming: Advance Mark X standard (no additional wires required); use compat-
ible dimmer. Dimming ballasts using additional control wires (eg Lutron Hi-Lume
or ECO-10, Osram) can be used; consult factory and use X4 or X5 power feeds
with additional leads, as appropriate. Ballast not to exceed 1.25” (3.18cm) wide by 
1.20” (3.05cm) high.
iGEN: F7000 accepts iGEN (DALI) with supplemental 2-wire control technology.
Use with X5 power feed.
Power Tray: Code-gauge, die-formed steel, pre-paint white enamel finish;
secured by quarter-turn fasteners for easy access to wiring. Holds ballasts, sock-
ets, and wiring. Accepts ballasts up to 1.25” (3.18cm) wide by 1.20” (3.05cm) high.

Powder-coated, baked enamel, white or aluminum, as specified.

Factory installed ballast disconnect allows the ballast to be disconnected from and 
reconnected to incoming power under load without turning the entire circuit off.

Individual Fixtures:
1. Order one MODULE.
2. Order one END SET.
Continuous Rows:
1. Order the appropriate number of MODULES for the complete run.
2. Order one END SET.

Powder coated White or Aluminum baked enamel. Custom colors are available,
consult factory.

UL , cUL and I.B.E.W.

Each module includes two wall-mounting brackets. Bracket hole pattern accom-
modates junction box (single gang box rotated 90 degrees) or other appropriate
mounting method using customer supplied fasteners.

Complete Ordering Instructions below.

1.63”
(4.14cm)

9.60” (24.38cm)

3.25”

(8.26cm)

7 = Wedge

6 = Wedge lens

1 = 1 Lamp

AL = Aluminum
WH = White

1 = 28W
2 = 54W
3 = 28W Dimming
4 = 28W EM
5 = 54W Dimming
6 = 54W EM

1 = 120v
2 = 277v

4 = 4’ (121.92cm)