Lightolier IS:26049 Fascicule

FALL RIVER, MASSACHUSETTS 02720
MONTREAL, QUEBEC, CANADA

 © 1997

READ AND UNDERSTAND ALL TRACK, CONNECTOR, FEED-IN-KITS, AND ACCESSORY

INSTRUCTION SHEETS BEFORE INSTALLING ANY PROSPEC™ TRACK ITEM.

This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications. To assure full compliance with codes and regulations, check with your local electrical
inspector before installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

™

Track Unit

Copper Wire

Contact  Blade

Fig. 1

Track Unit

Fig. 2

Invisible
Coupler

Align Arrows

Fig. 4

Secured  Screws

Track Unit

Track Unit

Bottom Cover

Secure  Screws if accessible
after Track is mounted.

Spline

The Mini Coupler is used to join two pieced of track together
mechanically and electrically. Power cannot be feed into the Mini
Coupler.

Caution:
• Turn off power at fuse box before installing the invisible

• Do not attempt to feed power to the invisible coupler.

INSTALLING CONNECTOR INTO TRACK SECTION
1. Remove Dead End Cover if necessary by pulling it out of Track

(save Dead End Cover). Fig 1.

2. Push Coupler into track until the arrows line up with the track

edge. Ensure that the contact blades are aligning with the copper
wires in the track during assembly. (Fig 2 & Fig 3)

3. Tighten the Locking Screw, (Fig 3)
4. Insert metal spline into the track approximately half the distance

of the metal spline length (Fig 5). Note orientation of spline in
channel.

5. Insert the assembled track and coupler into the mating track.

Ensure that the contact blades are aligning with the copper wires
in the track (Fig 2). Push together until there are no gaps between
the track unit sections. (Fig 4)

6. Check arrows on bottom of coupler. If arrows are not in line with

the edge of the track, realign the coupler until the arrows are in
line with the track edges.

7. Tighten locking screws. Note: if there is access from above the

track after it is mounted (ie. track stem installation) secure the
spline to the mating track using the (2) additional screws. Do not
use the additional two screws if there is no access. The track will
have to be removed from the structure to remove the invisible
coupler.

8. Snap the bottom cover into the track sections.

Remove Dead End

Invisible
Coupler

Track Unit

Locking Screw

Fig. 3

Fig. 5

Tighten Screws

Spline

Track Unit