Lightolier 1084WH Fascicule

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

1  FRAME-IN KIT INSTALLATION: See Frame-In Kit Instruction Sheet for installation procedure. 

INSTALLATION:  

A.  Align open side of gasket towards socket cup (figure A).   
B.  Pinch gasket and insert both edges under the reflector spring clip.  (figure B).  
C.  Push center of gasket back into socket cup until inner diameter fits over the lamp socket 

and smaller thru hole in gasket sits on top of socket (figure C). 

Figure A 

Figure B 

Figure C 

THE GASKET MUST SIT ON TOP OF SOCKET TO PROVIDE SEAL TO LAMP. 

Rotate (4) ROTO-CLIPS so that the short legs extend inwardly toward center 
opening (figure D).  
Note: The short leg of the ROTO-CLIP has no return on top. 

 

Figure D 

ON:  

Insert gasketed socket cup into neck of reflector trim making sure spring clips of 
socket cup snap into slots of reflector (figure E).  If reflector trim has 2 sets of slots, 
the upper slot is used for IC frame-in kits, the lower slot for non-IC frame-in kits. 
Note: At no time should the lamp extend outside the reflector trim. 

Figure E 

UP:   

Align Reflector Trim so that ROTO-CLIPS will not interfere with socket cup spring 
clips and push reflector trim straight up into fixture housing until it is tight against 
ceiling (figure F). 

Figure F 

 Note:  To remove reflector trim, turn reflector trim counterclockwise while pulling 

downward.  Once trim is out of the ceiling, squeeze reflector spring clips until the 
trim disengages from socket cup.  (figure G). 
 
Replacement Gasket Available: Lightolier Catalog No. LFG356 

Figure G 

 

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.  To 

assure full compliance with local codes and regulations, check with your local electrical inspector before 

installation.  To prevent electric shock, turn off electricity at fuse box before proceeding. 

INSTALLATION PROCEDURE FOR: 1184WH, 1184CD, 1084WH, 1084CD, 2084WH, 2084CD 

 COMPANY