Honeywell MS-9600UDLSE Manuel D’Utilisation

MS-9600LS Series Manual — P/N 52646:B2  2/12/2010

119

Programming



Pressing 2 for ACS Options while viewing the Annunciators screen, will display the following 
screen: 

Pressing 1 while viewing the ACS Options screen will cause the display to toggle between ACS 
Enabled Yes and ACS Enabled No.  To install an ACS annunciator, the display must read ACS 
Enabled Yes.

If ACS has been enabled, press 2 while viewing the ACS Options screen to select addresses for the 
ACS annunciators.  The following screen will be displayed:

Pressing the down arrow key will allow the programmer to view additional screens displaying 
Addresses 1 -31.  Each screen will indicate if an address has been used for an installed ACS annun-
ciator.  To select one or more addresses for the installed ACS annunciator(s), press the number key 
corresponding to the address in each screen.  The display for the selected address will change from 
No to Yes.  Each press of the number key will cause the display to toggle between No and Yes.  The 
address of each installed annunciator must be enabled to allow communication between the FACP 
and annunciator.

  ANNUNCIATORS

1=TERM OPTIONS

2=ACS OPTIONS

3=ANN-BUS OPTIONS

Annunciator Screen

    ACS OPTIONS

1=ACS ENABLED       NO

2=ACS INSTALLED

3=UDACT             NO

    ANNUNCIATOR

1=ADDRESS 1       YES

2=ADDRESS 2        NO

3=ADDRESS 3        NO