Azden 35XT Manuel D’Utilisation

Page de 12
5  
DISP 1/2 Button 
Press to switch the LCD Display between Ch. 1 and 2. 
 
LCD Display MODE Switching Button 
Press to switch the LCD Display to show the actual frequency number in MHz being 
used on each channel. 
 
PHONE Jack  
This jack allows you to monitor the sound.  If a stereo headphone is used, Ch. 1 will be 
heard on the left and Ch. 2 on the right. 
 
MIC OUT Jack 
The 330UPR is supplied with both mini-to-mini and mini-to-dual XLR cables. 
 
For mini jack microphone inputs: Use the supplied mini-to-mini cable.  Plug one 
end of the cable into the 330UPR Receiver and the other end into the micro-
phone input of the video camera. 
 
For 3-pin XLR microphone inputs: Use the supplied mini-to-dual XLR cable.  Plug 
the mini-plug end of the cable into the 330UPR Receiver (use the screw-down 
sleeve to secure it to the receiver) and plug the XLR ends into the microphone 
inputs on the video camera.  Ch. 1 is on the “Tip” and Ch. 2 on the “Ring”. 
 
Battery Compartment 
Remove the battery compartment lid by sliding it down.  Install two fresh alkaline “AA” 
batteries.  Make sure the battery polarity is correct as marked inside the battery com-
partment.  Alkaline batteries are preferred, but Azden’s 1HR-3U rechargeable Ni-MH 
batteries may be used. 
 
The tool to operate the channel UP and DOWN buttons is stored in the battery com-
partment. 
 
DC 6 Volt Input 
An optional AC adaptor/battery charger for Azden’s 1HR-3U rechargeable Ni-MH batter-
ies is available for the 330UPR.  For more information or to order these products, 
please visit the Azden website a
 or contact your Azden dealer.