Drolet 45283 Manuel D’Utilisation

 

35

 
Add one large piece of wood to the top of an established fire.  If it starts to burn on three sides within 
one minute, it is dry and seasoned and right for burning.  If it turns black and starts to burn in about 
three minutes or more, it is damp.  If it turns black and does not start burning until five minutes or 
more, it is green and wet. If it hisses at any time, the wood is soaked and will not burn until the 
excess of moisture is boiled away. 
 

 
The fresh paint on your stove needs to be cured to preserve its quality. Once the fuel load is properly 
ignited, only burn small fires in your stove for the first four hours of operation. Never  open the air 
control more than necessary to achieve a medium burn rate. Make sure that there is enough air 
circulation while curing the stove. Open one or more windows.  The odours can be smelled during 
the 3 or 4 first fires.  Never start your stove outside. 

 

 

1.  Place enough crumpled balls of newspaper or other paper into the stove to cover the bottom 

of the firebox. 

 

2.  Place small and dry kindling on the crumpled paper. 

 

3.  Place larger and dry kindling on top of the small kindling. 

 

4.  Open the air intake control fully. (see Table 3.4) 

 

5.  Light a fire at the bottom of the crumpled paper and close the door. If the fire tends to go out 

 momentarily, hold the door slightly ajar to activate the fire.  As soon as the fire catches hold, 
close the door. 

 

6.  Ideally the large kindling should be burned until a thick bed of red embers is obtained.  At 

that point, add cord wood fuel and continue to operate the draft control wide open until the 
fire is well established.  Once the firebox is hot, the air control can be partially closed to 
adjust the intensity of the fire.  Refer to table 3.4 to operate the air intake control properly.