England's Stove Works 13-NCP 50-SNC13P 50-TNC13P Manuel D’Utilisation

Air Inlet Control 

Illustration 7 

* 

Remove bricks, disconnect flue, and turn stove on its back. 

*  If you are replacing existing legs or pedestal, disconnect the 

existing legs or pedestal. 

 

To install legs: 
1. Each leg will fit into a pre-made slot on each corner of the 

bottom of the unit.   

2. A 3/8” x 1-1/2” Carriage Bolt and matching nut is supplied with 

each leg.  Fit a leg into a slot, and match the hole on the leg 
with the hole in the slot.  Attach the legs one at a time, using 
the supplied bolts and nuts.  Tighten securely. 

 

To install pedestal: 
1. Place spacers (provided) between the slots on the unit and the 

pedestal base (one spacer will fit on each side of the 
pedestal).  Match the four holes in the pedestal (2 on each 
side) with the holes in the spacers and slots on the unit. 

2. Use the four 3/8” x 1-1/2” Carriage Bolts and nuts (provided) to 

attach the pedestal to the base of the stove.  Tighten securely. 

*  After attaching the legs or pedestal, turn unit upright, 

reconnect flue and replace bricks according to manual. 

Pedestal 

Legs 

Spacers (for 
pedestal only)