Hoover Canisfer Cleaner with Power Nozzle Manuel D’Utilisation
Lubrication
The motor is equipped with bearings, which have been lubricated for the life
of the motor. The addition of lubricant could cause damage.
of the motor. The addition of lubricant could cause damage.
Therefore, do
not add lubricant to either motor bearing.
The agitator is equipped with two ball bearings that should be lubricated
periodically by a Hoover Factory Service Center or an Authorized Warranty
Service Dealer.
periodically by a Hoover Factory Service Center or an Authorized Warranty
Service Dealer.
If you have a problem
This appliance was inspected thoroughly and was in good operating
condition when it was shipped from the factory. If a minor problem occurs,
it usually can be solved quite easily when the cause is found. Therefore,
this check list is provided to assist you.
Problem
Possible cause
Possible solution
Cleaner
run
1. Not firmly plugged in.
2. No voltage in wail plug.
3. Blown fuse/tripped breaker.
3. Blown fuse/tripped breaker.
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
3. Replace fuse/reset
breaker.
Cleaner
suction
low
low
1. Bag full.
2 Obstruction in hose,
wands, or nozzle connector.
3. Secondary
dirty.
4 Bag not opening.
5. Suction regulator control
improperly set.
Hose not property con-
to cleaner.
1. Change paper bag.
2. Remove foreign object.
3. Clean filter.
.
5. Adjust suction regulator.
6. Reconnect hose.
C. Agitator
won’t run
1. Hose power cord not
firmly plugged in.
2 Broken or worn
3. Nozzle sealed to carpet
3. Nozzle sealed to carpet
1. Plug
into receptacle
on cleaner base and
underneath hand grip.
underneath hand grip.
2. Replace
3. Open suction regulator.
3. Open suction regulator.
D. Nozzle
won’t
pick up
1. Low cleaner suction.
2 Obstruction in nozzle
connector.
3. Agitator not running.
4. Agitator brushes worn.
4. Agitator brushes worn.
1.
2. Remove foreign object.
3. see item c.
4. Replace brushes.
4. Replace brushes.
17