Philips MCD119/12 Manuel D’Utilisation
18
English
IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
– Make sure to complete the
preparation procedures before operating
the system.
Before using the remote control
1
Pull out the plastic protective sheet.
2
Select the source you wish to control by pressing
one of the source select keys on the remote
control (for example DISC, TUNER).
one of the source select keys on the remote
control (for example DISC, TUNER).
3
Then select the desired function (for example
ÉÅ , à , á).
ÉÅ , à , á).
Replacing battery (lithium
CR2025) into the remote control
CR2025) into the remote control
1
Press the slot on the battery compartment.
2
Pull out the battery compartment.
3
Replace a new battery and fully inser t the
battery compartment back to the original
position.
battery compartment back to the original
position.
1
2
3
CR2025
CAUTION!
Batteries contain chemical substances, so
they should be disposed of properly.
Batteries contain chemical substances, so
they should be disposed of properly.
Preparations
Step 2: Setting the clock
1
Go to Standby mode.
2
Press and hold DISPLAY/CLOCK on the
remote control.
remote control.
➜
"
SET CLOCK" is displayed briefly. Then, the
hour digits flash on the display screen.
3
Press VOLUME +/- on the front panel or VOL
+/-
+/-
on the remote to set the hours.
4
Press DISPLAY/CLOCK again.
➜
The minute digits flash on the display screen.
5
Press VOLUME +/- on the front panel or VOL
+/-
+/-
on the remote to set the minutes.
6
Press DISPLAY/CLOCK to confirm the clock
setting.
setting.
Notes:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 20 seconds.
– The clock setting will be erased when the system
is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 20 seconds.
Remove the plastic protective sheet
pg001-pg035_MCD119-12-Eng
2007.8.13, 11:06
18