Philips DVP3982/37 Manuel D’Utilisation

6

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Ensure that the AC outlet have power.
–  Disconnect the power cord from the power outlet. 

Reconnect and try again after a few minutes.

–  Refer to your TVs manual for correct Video In 

channel  selection. Change the TV channel until you 
see the DVD screen.

–  If this happens when you turn on the progressive scan 

feature, wait for 15 seconds for the auto recovery or 
switch back to the default mode as below:

1) Press ç  to open the disc tray.
) Press numeric keypad ‘1’ on the remote control. 

–  Check the video connection.
–  Ensure that the disc is compatible with this unit.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

–  Check the audio connections to the connected audio 

device.  

–  Make sure that the connected audio device is turned 

on to the correct input source.

–  Set the digital output setting correctly, based on the 

device you connected to this unit. See ‘Audio Setup 
Page – Digital Audio’ for details.

WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidate the 
warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, first check the points listed below before taking this unit for repair. If you 
are unable to remedy a problem by following these hints, consult your dealer or Philips for 
help.

dvp3962_3982_37_eng1.indd 46

2008-05-05 2:17:59 PM