Sony DSR-390L Manuel D’Utilisation
Chapter 5
Adjustments and Settings
129
Chapter 5 Adjustments and Settings
1
2
If black balance adjustment cannot be
completed automatically
completed automatically
The warning message “AUTO BLACK -NG-” appears
in the viewfinder.
Make the necessary corrections, then carry out the
process again.
in the viewfinder.
Make the necessary corrections, then carry out the
process again.
Warning messages for black balance adjustment
Message
Meaning and corrections to be made
AUTO BLACK
-NG-
: IRIS
NOT CLOSED
TRY AGAIN
The lens iris did not close fully.
Check whether the lens cable is
connected properly, and whether there is
a fault in the lens. If a second attempt to
carry out the adjustment fails, consult
your Sony dealer.
Check whether the lens cable is
connected properly, and whether there is
a fault in the lens. If a second attempt to
carry out the adjustment fails, consult
your Sony dealer.
AUTO BLACK
-NG-
:
??
TRY AGAIN
The iris opened during adjustment or
there is a hardware error.
Close the iris and try again. If this fails,
consult your Sony dealer.
there is a hardware error.
Close the iris and try again. If this fails,
consult your Sony dealer.
Black Balance Adjustment
Correct adjustment of the black balance is important
for optimum operation of a camcorder. It is necessary
when using the camcorder for the first time or after a
significant period out of use, and also when there has
been a sudden change in temperature.
The adjustment value is saved in memory, and
readjustment is not normally necessary after powering
the camcorder off or simply when lighting conditions
change.
for optimum operation of a camcorder. It is necessary
when using the camcorder for the first time or after a
significant period out of use, and also when there has
been a sudden change in temperature.
The adjustment value is saved in memory, and
readjustment is not normally necessary after powering
the camcorder off or simply when lighting conditions
change.
1
Turn on the power and check that the OUTPUT/
DL/DCC+ switch is in one of the CAM positions.
DL/DCC+ switch is in one of the CAM positions.
2
Push the WHT/BLK switch in the BLK direction
and release.
The lens iris closes, and black balance adjustment
is carried out.
During the adjustment the legend “AUTO BLACK
-OP-” appears in the viewfinder.
and release.
The lens iris closes, and black balance adjustment
is carried out.
During the adjustment the legend “AUTO BLACK
-OP-” appears in the viewfinder.
After a few seconds the adjustment is complete,
and the legend in the viewfinder changes to
“AUTO BLACK -OK-”.
and the legend in the viewfinder changes to
“AUTO BLACK -OK-”.
BARS
The camcorder is outputting a color bar
signal.
Move the OUTPUT/DL/DCC+ switch to
one of the CAM positions.
signal.
Move the OUTPUT/DL/DCC+ switch to
one of the CAM positions.