Dolmar HT-2556 D Manuel D’Utilisation

Page de 20
5
6
7
10
9
8
-  Fuels can contain substances similar to solvents. Eyes and skin 
should not come in contact with mineral oil products. Always wear 
protective gloves when refuelling. Frequently clean and change 
protective clothes. Do not breathe in fuel vapors. Inhalation of 
fuel vapours can be hazardous to your health.
-  Do not spill fuel or oil. When you have spilt fuel or oil immediately 
clean the hedge trimmer. Fuel should not come in contact with 
clothes. If your clothes have come in contact with fuel, change 
them et once.
-  Ensure  that  no  fuel  or  oil  oozes  into  the  soil  (environmental 
protection). Use an appropriate base.
-  Refuelling is not allowed in closed rooms. Fuel vapors will  ac-
cumulate near the floor (explosion hazard).
-  Ensure to firmly tighten the screw plugs of the fuel tank.
-  Change the place before starting the hedge trimmer (at least 3 
m from the place of refuelling) (6).
-  Fuel cannot be stored for an unlimited period of time. Buy only 
as much as will be consumed in the near future.
-  Use only approved and marked containers for the transport and 
storage of fuel. Ensure children have no access to fuel.
Starting operation
-  Do not work on your own. Another person must be nearby 
in case of emergencies (within shouting distance).
-  Make sure that there are no children or other persons within the 
hedge trimmer work zone (at least 15 m / 50 ft. away). Look out 
for animals (7).
-  Before starting work check to make sure that the trimmer 
is in good and safe working order. This is a must!
  Be certain that screws and bolts are tightly seated, the cutter is 
sharp and undamaged, the throttle works easily, the safety cutoff 
functions properly, the grips are clean and dry and the Start/Stop 
switch works properly.
-  The hedge trimmer must not be used unless fully assembled! 
-  Make  sure  you  have  a  secure  footing  before  starting 
operation.
-  Start the trimmer only as described in the Instruction Manual (8 
or 9). Do not use any other starting methods.
-  During starting, place the tool on a stable surface and hold it 
steady. The cutter most not be obstructed.
-  Always hold the trimmer with both hands when working
One hand on the rear grip, the other on the front grip. Hold each 
grip with your thumb around it.
-  CAUTION: The blade will still run for a short time after you 
release the throttle (free-running effect).
-  Before starting the hedge trimmer ensure that you have a safe 
footing.
-  Use the trimmer in such a way that exhaust cannot be inhaled. 
Do not work in enclosed spaces (poisoning hazard).
-  Immediately turn off the engine if there is any noticeable 
change in the way the tool runs.
-  Always turn off the engine before checking the condition 
of the tool, taking care of problems or refuelling (10).
-  Always turn off the engine before removing any jammed cuttings 
from the cutter.
-  If the cutter touches rocks, nails or other hard objects, immedi-
ately switch off the engine and check the blade.
-  When stopping work or leaving the working place switch off the 
hedge trimmer (10) and put it down such that nobody is endan-
gered.
-  Do not put the overheated power hedge trimmer  in dry grass 
or on any inflammable objects. The muffler is very hot (danger
of fire).
3 meters
HT-2556 D
HT-2576 E
● 
Maintenance
● 
Stopping work 
● 
Refuelling
● 
Transport 
● 
Putting out of function