Snapper ESPV21 Manuel D’Utilisation

Section 3 – MAINTENANCE

WARNING

DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool. Wear heavy leather gloves
when handling or working around cutting blades.
Blades are extremely sharp and can cause severe
injury.

3.3.4. Wheel Drive Components
1. Remove rear cover. Refer to Section “Rear Cover
Removal & Installation”.
2. Clean debris buildup on or around transmission,
axles, idler, pulleys, belt, etc., as well as on underside
of cover. Check components for wear or damage.
Replace worn or damaged components immediately.
3. Replace rear cover.

IMPORTANT: DO NOT operate mower without rear cover
securely in place.

3.4 STORAGE

PROCEDURE

Refer to the Engine Owner’s Manual for directions

regarding engine storage preparations. Prepare the

mower for “end of season” storage as follows:

1. Drain fuel from fuel tank and let engine run until

all fuel is out of the carburetor.

2. Disconnect and remove the spark plug wire

away from spark plug before any other preparations

are made!

3. Tape all openings closed to prevent spraying

water into exhaust or air intakes during washing.

4. Tilt mower up on its rear wheels and thoroughly

clean the underside of the deck. Do not tilt mower

with spark plug or carburetor down. Scrape away

any accumulation of grass with a putty knife and or

wire brush.

5. Lubricate all exposed metal with a light coating

of oil to prevent corrosion.

6. On self-propelled models, move ground speed

control back to slow (‘turtle’) position to prevent

stretching of belt and/or idler spring.

7. Carefully fold the handles, “flexing” the control

cables to prevent cable damage.

8. Store the mower in a shed or other dry area,

protected from weather.