Runco CR-26HD Manuel D’Utilisation
Runco CR-26HD/CR-32HDi Owner’s Operating Manual
23
PRE
L
IMINAR
Y
4.1
Turning on the Power
Turning on the Power
1.
Turn on your source components.
2.
Plug the female end of the power cord into the AC receptacle on the rear of the
Crystal Series LCD Display (AC 100V ~ 240V).
Crystal Series LCD Display (AC 100V ~ 240V).
3.
Connect the other end to your AC power source.
4.
Turn on the main power switch at the rear of the display (CR-32HDi only).
5.
The power indicator lights red to indicate that the Crystal Series LCD Display is in
“standby” mode.
“standby” mode.
6.
Press the ON button on the remote control to
turn on the display (or press the power button
on the front of the display). The power
indicator flashes for a few seconds, then lights
solid green.
turn on the display (or press the power button
on the front of the display). The power
indicator flashes for a few seconds, then lights
solid green.
7.
After a brief warm-up period (approximately
10 seconds), the Crystal Series LCD Display
will display an image.
10 seconds), the Crystal Series LCD Display
will display an image.
4.2
Changing the OSD
Language
Changing the OSD
Language
The Crystal Series LCD Display OSD language is initially set to English, but can also
display the menus in French, Spanish, Portuguese or German. To change the OSD
language:
display the menus in French, Spanish, Portuguese or German. To change the OSD
language:
1.
Press MENU.
2.
Select Setup from the Main Menu.
3.
Select OSD Language from the Setup Menu.
4.
Press
or
to highlight the desired language and press ENTER. The change takes
effect immediately.
4. Operation
4
5
0
100
1
2
3
6
TIMER
TIMER
OFF
OFF
INPUT
INPUT
1
7
8
9
OFF
ON
INPUT
INPUT
2
INPUT
INPUT
3
SOURCE
-
SLEEP