Enterasys csx400 Mode D'Emploi
Configuration: Call Backup
Local Management User’s Guide
2-43
Use the Network Tools commands ct and dt to test the line by doing a manual connect or
disconnect:
disconnect:
ct [IFACENUM]
connects (places) a call for the interface designated.
dt [IFACENUM]
disconnects (hangs up) the call.
These three Network Tools commands allow the user to check whether or not the ISDN line and
profile(s) have been configured properly and that a connection is possible.
profile(s) have been configured properly and that a connection is possible.
Configuration is complete.
Reset
If the Telco must be re-initialized, the host platform must be reset or the ISDN line must be
disconnected. Refer to the host platform user’s guide to reset the platform.
disconnected. Refer to the host platform user’s guide to reset the platform.
NOTE
When reconfiguring an interface, the host platform does not have to be reset.