Hannspree hannsgolf Mode D'Emploi
56
4.2
Troubleshooting
Note:
• Do not place the remote control in hot or humid locations.
Protect the remote control from shock or vibration to avoid
damages.
damages.
• Check the remote control batteries on a regular basis. Clean
any stain on the rear battery cover immediately and use new
batteries if fluid is leaking from old batteries.
batteries if fluid is leaking from old batteries.
No picture and
sound.
sound.
• Connect the power cord properly.
• Press the POWER key on the control panel or
remote control.
• Press the SOURCE key to cycle through
connected video sources.
• Press CH UP or CH DOWN to switch to other
TV stations.
• Check the TV/CATV OSD settings.
• Make sure all cables are connected properly.
No picture, or poor
picture, but sound
is OK.
picture, but sound
is OK.
• Check the antenna and cable connections.
• Adjust the brightness in the OSD menus.
• Make sure the video signal cable is
connected properly.
Picture is not in
color.
color.
• Adjust the saturation in the OSD menus.
• Make sure all cables are connected properly.