Sanyo PLC-XP200L Mode D'Emploi

Before calling your dealer or service center for assistance, check the items below once again.

1.  Make sure you have properly connected the projector to peripheral equipment as described on pages 22–24.

2. Check the cable connection. Make sure that all computers, video equipment, and power cords are properly 

connected.

3. Make sure that all power is switched on.

4. If the projector still does not produce an image, restart your computer.

5. If an image still does not appear, disconnect the projector from your computer and check your computer 

monitor’s display. A problem may be noticed with your graphics controller rather than with the projector. 

(When you reconnect the projector, be sure to turn the computer and monitor off before you turn on the 

projector. Turn on equipment in the order of the projector and computer.)

6. If a problem still persists, check the following solutions.

– Plug the power cord of the projector into the AC outlet.
–  Wait  until  the  POWER  indicator  stops  blinking  to  turn  on  the  projector  again.  (See 

page 26)

–  Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator is blinking, the 

projector cannot be turned on. (See page 68.)

– Unlock the Key lock function for the projector.  (See page 57)

–  See if the filter cartridge is inserted.  (See page 62)

– Check the projection lamp.  (See page 64.)

–  PIN code lock is being set. Enter a PIN code; the “1234” or numbers you have set 

(See pages 26, 57-58)

– Make sure “Off ” or “Countdown Off” are not chosen at Display function.

   (See “SETTING” section on page 52)

– Make sure “User” or “Off” are not chosen at Logo select function.

   (See “SETTING” section on page 53)

– That is the Filter warning icon. (See page 61.)

–  That is the Lamp replacement icon or the Filter warning icon.  (See page 60-61.)

– Check the connection between your computer or video equipment and the projector.
–   See  if  the  input  signal  is  correctly  output  from  your  computer.  Some  laptop 

computers may need to be changed the setting for monitor output when connected 
to the projector. See your computer’s instruction manual for the setting.

– It takes about 30 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video equipment.
–   Select correct input source once again through menu operation  (See pages 35-37).

–  Make  sure  the  temperature  is  not  out  of  Operating Temperature  (41˚F–104˚F  [5˚C–

40˚C]).

–  End of lamp life is approaching. Replace the lamp with a new one promptly.  (See 

pages 59, 64-65)