Sanyo PLC-XP200L Mode D'Emploi

  This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face 

of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, 
marked thus 

. If the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover 

is required, ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers 
are available from the Parts Department indicated in your User Instructions.

  If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.
  The end of the flexible cord should be suitably prepared and the correct plug fitted. (See Over)

 

The Wires in this mains lead are coloured in accordance with the following code:

   

Green-and-yellow ············· Earth

   

Blue ································· Neutral

   

Brown ······························ Live

  As  the  colours  of  the  wires  in  the  mains  lead  of  this  apparatus  may  not  correspond  with  the  coloured  markings 

identifying the terminals in your plug proceed as follows:

  The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter 

E or by the safety earth symbol   or coloured green or green-and-yellow.

  The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
  The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.  

  AC  Power  Cord  used  in  the  United  States  and  Canada  is  listed  by  the  Underwriters 

Laboratories (UL) and certified by the Canadian Standard Association (CSA).

  AC  Power  Cord  has  a  grounding-type AC  line  plug.   This  is  a  safety  feature  to  be  sure  that 

the plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be 
unable to insert the plug into the outlet, contact your electrician.

GROUND

Note: This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device,  pursuant  to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference 
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to 
try to correct the interference by one or more of the following measures:
  – Reorient or relocate the receiving antenna. 
  – Increase the separation between the equipment and receiver. 
  – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
  – Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.
Do  not  make  any  changes  or  modifications  to  the  equipment  unless  otherwise  specified  in  the  instructions.  If  such 
changes or modifications should be made, you could be required to stop operation of the equipment.
Model Number  

: PLC-XP200L 

Trade Name  

: Sanyo 

Responsible party  

: SANYO FISHER COMPANY 

Address  

: 21605 Plummer Street, Chatsworth, California 91311, U.S.A.

Telephone No.  

: (818)998-7322