Sanyo PLV-Z3000 Mode D'Emploi

This projector uses nominal input voltages of 100 – 120 V or 200
– 240 V AC and it automatically selects a correct input voltage. It is
designed to work with the single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service station.
Connect the projector with all peripheral equipment before turning
it on.

CAUTION

The AC outlet must be near this equipment and must be easily
accessible.

Connecting the AC Power Cord

Connect the AC power cord (supplied) to the
projector.

Installation

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side

AC Outlet side

To POWER CORD
CONNECTOR on your
projector.

Ground

To the AC Outlet.

(120 V AC)

For Continental Europe

For the U .S .A . and Canada

For the U .K .

To the AC Outlet.

(200–240 V AC)

To the AC Outlet.

(200–240 V AC)

✔

Note:

• Unplug the AC power cord when the projector is not in use.
When the projector is connected to an outlet with the AC power

cord and the Main On/Off switch is on, it is in stand-by mode and
consumes a little electric power. Turn the Main On/Off switch off
when the projector is not in use.